Using the Canon Service Tool V-4713 without proper authorization or training may void your printer's warranty or cause damage to the printer.
When your machine triggers hard-stop notifications like (Ink Absorber Full), it stops printing completely. This tool acts as the bridge needed to clear those codes, reset maintenance internal tallies, and run advanced diagnostic routines. Why You Need Canon Service Tool V-4713
The Canon Service Tool cannot communicate with a printer running in normal printing mode. You must manually boot the hardware into before opening the application. Follow these steps precisely:
While holding Power, release Stop and then press it five times (number of presses may vary by model).
The Canon Service Tool V-4713 is an official service software application designed for technicians and advanced users to perform maintenance operations on Canon Pixma, Maxify, and G-Series printers.
You need a newer service tool (e.g., V5204 or V5400). Always double-check your exact model number.
Used after replacing hardware parts like the logic board or print head to ensure the new components are correctly recognised by the system. Supported Models
This software allows users to access the printer’s internal maintenance system to:
Ensure the printer is off but plugged into a power source.
While keeping the button held, release the Stop/Reset button.
Go to the Ink Counter section, select Main , and click Set to reset overall ink memory levels if prompted by error codes.
Allows users to read, dump, or clear the printer's non-volatile memory data.
Displays firmware versions and exact page print counts. Compatible Canon Printer Models
Look at the top of the program window. If your buttons are active and clickable, the software successfully detected your machine. If the choices are greyed out, your printer is not in Service Mode or your USB cable is faulty.
Legitimate use cases