Phison Mpall V5.13.0c

Note the (e.g., Toshiba, SanDisk, Micron), as you will need matching firmware later. Step 2: Preparing the Files

Browse and map the slot to your downloaded BNxx.BIN file.

: If the drive is seen as "Mode 3" and is write-protected, you may need to use in Windows to clear attributes before flashing. Red Drive Display

Wait for the progress bar to turn green. during this process. Common Troubleshooting "CT - Read Config File Error" Phison Mpall V5.13.0c

You may need to manually trigger Test Mode . Carefully open the plastic housing of the USB drive. Locate the Phison controller chip. Using a sewing needle or a fine-tip tweezer, short-circuit the 29th and 30th pins on the controller chip while plugging it into the USB port. This forces the hardware directly into a hardware safe-mode, allowing MPALL v5.13.0C to see the device and rewrite the corrupt firmware blocks. Conclusion

: Removes permanent "Write-Protected" logic loops. Prerequisites Before Flashing

The Ultimate Guide to Phison MPALL V5.13.0C: Revive and Repair Your Phison USB Drive Note the (e

Download a hardware diagnostic tool like or Flash Drive Information Extractor (FDIE) . Plug in your corrupted USB drive.

Right-click and select Run as Administrator . This utility generates the custom parameters for the main flashing application. When prompted, select Advance Setting and click OK .

: This is the actual operating system code for the USB controller. Red Drive Display Wait for the progress bar to turn green

Because MPALL is an industrial factory tool, it does not feature an automated "one-click" repair process. You must manually define your hardware parameters using its built-in configuration compiler.

If ChipGenius identifies your drive with a controller not on this list, you must find a tool specifically for that controller. Using the wrong MPALL version can "brick" your drive, making it completely unrecognizable.

Before downloading Phison MPall v5.13.0c, you must verify your drive uses a Phison chip. Use these methods: