As John approached the copier, he noticed that it had been acting strangely all weekend. The machine had been jamming constantly, and the error message had started appearing intermittently. Now, it seemed to be stuck in a loop, beeping and flashing the error code every few seconds.
Ensure they are firmly seated. If the device has been moved recently, these cables can often wiggle loose.
. It specifically triggers when the "Flair communication" (the signal between the panel and the main board) is not established or recognized. Quick Fix: Power Cycle
Because firmware corruption is the #1 cause, this should be your next step. sc673-10 ricoh error
Before the error code permanently locks the machine, you might observe one or more of the following symptoms:
If the error persists, physical communication lines must be checked.
Ricoh uses Service Call (SC) codes to categorize hardware and software malfunctions. The 600-series codes specifically denote communication errors between various internal modules. As John approached the copier, he noticed that
Before opening the machine, eliminate residual electrical capacitance or temporary software lockups.
Before attempting advanced service resets, try these basic fixes to resolve temporary communication glitches:
Insert the media into the designated service slot on the controller board or side of the panel. Ensure they are firmly seated
Periodically apply stable firmware updates recommended by Ricoh to patch known communication bugs and improve system stability.
Tools: 2GB or smaller SD card (FAT16/FAT32 formatted), Ricoh Firmware Package.
If these basic steps do not resolve the issue, it is highly likely that either the or the Controller Board requires replacement. You should contact an authorized Ricoh Support technician to diagnose hardware-level circuit failures.
A: No. The machine enters SC mode—it will not copy, print, or scan until the error is cleared.
Knowing this will allow me to provide specific part numbers or service manual access steps. Share public link