Acer Aahd3vc Motherboard Manual Install Guide

Align the notch on the bottom of the RAM stick with the ridge inside the slot.

Secure the board using standard motherboard screws. Tighten them firmly, but do not overtighten, as this can crack the PCB circuit traces. Front Panel Header Pinouts (Critical Step)

Connects to the two pins responsible for turning the PC on. Orientation does not matter for switches.

Gently lower the processor straight down into the socket. If it is aligned correctly, it will drop into place smoothly. acer aahd3vc motherboard manual install

Whether you are using a or relying on integrated graphics?

Connect your monitor to the motherboard's HDMI or VGA port (or to your dedicated graphics card if installed). Plug in your keyboard, mouse, and power cable.

USB 2.0/3.0 ports, VGA, HDMI, RJ-45 Ethernet, Audio Jacks. Pre-Installation Requirements Align the notch on the bottom of the

Connects to the two leftmost pins on the bottom row. (Ensure positive [+] is on the left and negative [-] is on the right). Front Panel Audio (F_AUDIO) and USB (F_USB)

Install the storage drive:

: LED cables (Power and HDD) must be connected to the correct positive/negative pins to light up. If the LED doesn't work, flip the connector. The Power and Reset switches will work regardless of orientation. 3. Installation Steps Explaining PC Front Panel Connectors Front Panel Header Pinouts (Critical Step) Connects to

4x DDR3 DIMM slots (Supports dual-channel, DDR3 1866/1600/1333/1066 MHz, Max 32GB). Form Factor: Micro-ATX (Approx. 244 mm × 244 mm). Expansion Slots: 1x PCIe x16 (Graphics) 1x PCIe x1 Storage: 5x SATA 6Gb/s ports (SATA3). Audio: Integrated 5.1 High Definition Audio. Networking: Realtek Gigabit LAN. Rear I/O: USB 3.0, USB 2.0, VGA, HDMI, Audio Jacks, RJ45. 2. Motherboard Layout Overview

1 x PCI Express x16, 2 x PCI Express x1, 1 x PCI Slot

Note: For the LEDs, if the lights do not illuminate when you turn the PC on, turn off the system and flip the connector orientation around. Front Panel Audio (F_AUDIO) & USB

Install the into the back cutout of your PC case by pressing it from the inside out until it clicks into place.