A: Yes. For ongoing patching, it is often recommended to use the most recent Cisco Custom ISO for the initial install, and then use the standard (non-custom) VMware offline bundles for subsequent security patches. The packages in the standard VMware bundle will not conflict with the Cisco drivers, as the standard bundle contains older or fewer drivers than the Cisco custom variant.
VMware downloads have transitioned to the Broadcom Support Portal. Follow these steps to locate the verified custom ISO:
Do you use or standalone host flashing?
Once verified, you can map the ISO to your Cisco UCS server using the integrated management tools: Log into your or UCS Manager . Open the KVM Console . Click on Virtual Media -> Activate Virtual Devices . download cisco custom image for esxi 70 u3 verified
A common question: “Can I apply a standard VMware patch to a system that was installed with the Cisco custom ISO?”
Downloading the correct image is only half the battle. Cisco requires that the driver version inside the ESXi 7.0 U3 image matches the firmware running on your UCS Fabric Interconnects and server chassis.
: Always verify the SHA256 checksum provided on the Broadcom download page against your downloaded file to ensure integrity. A: Yes
Once logged in, look for and select the "" section on the left-hand side of the portal menu.
Go to the (formerly VMware Customer Connect) and log in.
Are you planning a or an in-place upgrade from an older version? VMware downloads have transitioned to the Broadcom Support
Use tools like Rufus to burn the ISO image onto a high-quality, vendor-approved USB flash drive or SD card for local installation.
Here is the step-by-step guide to finding, verifying, and downloading the correct Cisco custom image for ESXi 7.0 Update 3 (U3). Why Use the Cisco Custom Image?