For curtain motor configuration, HBST2 allows setting the switch limiting position of curtains, defining travel limits, and configuring motor behavior.
Which part of the are you working on right now? Share public link
Maintain a consistent numbering system for Subnet IDs to avoid conflicts.
The "Scenes" tab allows you to design lighting scenes and link them to panel buttons.
Automatically scans the entire Buspro network, detects all connected devices (panels, sensors, actuators, gateways), and generates an interactive — no manual addressing or ID entry required. hdl buspro setup tool 2
Upon opening Buspro Setup Tool 2, you will be prompted to create a new project.
Successful communication between HBST2 and HDL devices requires proper network setup. The computer must be able to communicate with HDL IP modules or wireless gateways, often requiring setting a static IP address on the network adapter.
Define static lighting looks across an entire room. Setup Tool 2 allows you to save up to 12 or 24 scenes per actuator.
Setup Tool 2 allows you to flash firmware upgrades directly to individual modules over the network to unlock new features or stability patches. For curtain motor configuration, HBST2 allows setting the
This is where the magic happens. By grouping different device channels into a , you can trigger a "Movie Mode" that dims lights and closes curtains with a single button press. Pro Tips for Efficient Setup
HDL IP gateways typically come with factory default IP address 192.168.10.250 and port 6000. To connect:
The is the official configuration software for HDL’s Buspro wired automation system. It replaces the original "Setup Tool," offering a modernized user interface, faster device discovery, and enhanced stability.
Double-click a device to open its specific settings. For a , you can name each channel (e.g., "Kitchen Lights") and set "Power-on States" to ensure lights stay off after a power failure. For Sensors , you can adjust sensitivity levels and lux thresholds. 4. Setting Up Scenes and Sequences The "Scenes" tab allows you to design lighting
Open the software and use the "Scan Device" function. The software will ping the bus and identify all connected devices. In Setup Tool 2, this process is faster and will often automatically populate the device list with the correct model numbers.
Click the Search button. The tool sends a broadcast signal across the network. Devices will populate in a list, showing their current Subnet ID, Device ID, and model type.
HBST2 supports three working modes for IP gateways:
It seems you’re asking about — likely referring to a BusPro configuration or setup tool (version 2) used with HDL (a brand for home/building automation systems, especially in lighting control).