Complete Guide to the Machinist X99 MR9A Pro BIOS: Explaining the Exclusive Features
The MR9A Pro usually ships with Microcode 0x38 (Broadwell-EP) and 0x27 (Haswell-EP) revisions.
Understanding your hardware limits is essential before modifying any low-level firmware settings.
Chinese X99 motherboards usually do not have BIOS write protection enabled by default. If yours does, you must enter the stock BIOS, navigate to , and change BIOS Lock to Disabled . Place your modified.rom into the FPT folder. Open Command Prompt as Administrator. Execute the flash command: fptw64 -f modified.rom machinist x99 mr9a pro bios exclusive
Modifying a motherboard BIOS carries inherent risks. Follow these steps meticulously to avoid bricking your Machinist X99 MR9A Pro. Prerequisites A high-quality USB flash drive (formatted to FAT32).
Before exploring the BIOS, it is essential to understand what makes the MR9A Pro's hardware so appealing.
If your board is bricked, do not panic. You can recover it using an external hardware programmer: Complete Guide to the Machinist X99 MR9A Pro
Intel Xeon E5-2600 V3 processors (such as the popular E5-2678 v3 or E5-2640 v3) feature a factory flaw/exploit. Under normal conditions, their maximum Turbo Boost frequency drops when all cores are loaded. A custom BIOS applies a specific EFI driver ( V3x2_All_Core_Turbo_Unlock ) that tricks the CPU into running its maximum single-core turbo frequency across . 2. Undervolting Capability
(Invoking related search terms tool...)
Navigate to and change EIST (Enhanced Intel SpeedStep Technology) to Enabled . Set Turbo Mode to Enabled . 2. Boot and Compatibility Settings Go to the Boot tab. If yours does, you must enter the stock
The exclusive world of Machinist modding has a dark side. Because there are multiple hardware revisions (v1.0, v1.2, v2.1), .
The turbo unlock is typically applied by flashing a pre-modified BIOS. For users who want to modify their own BIOS:
One freelance motion graphics designer reported replacing an aging i7-4770K rig with a Machinist MR9A PRO + Xeon E5-2680 v3 setup. Their key observations:
Always keep a physical CH341A external programmer and an SOIC8 clip nearby. This hardware tool allows you to physically clamp onto the BIOS chip and rewrite the original firmware using a separate computer if a bad flash occurs.