Enable the USB ports to read media directly from external hard drives. Prerequisites and Preparation
: Unlocking or modifying system files will void your manufacturer warranty and may breach your service agreement with your ISP.
: Power on the device while holding the "Reset" button (usually found on the side or bottom) to access the bootloader menu .
Navigate to the file manager, select the APK, and install it. Note: This does not remove operator restrictions, and some apps may not work due to locked system settings. Risks and Technical Considerations
, plug the USB male-to-male cable into the USB 1 port of the STB and the other end into your PC. zte zxv10 b760hs2 unlock
Transfer this file to your PC. You can restore it via USB Burning Tool later.
Most flashing and debugging tools for MediaTek chips run natively on Windows.
Last updated: October 2025. Always verify your PCB revision (V1.0, V2.0, V3.0) before flashing.
Once the system reboots into a clean Android environment, execute these optimization steps: Enable the USB ports to read media directly
If you‘re stuck at this stage, community forums like XDA Developers are your best resource for model-specific solutions.
Look at Device Manager. You should see a brief flash of "MTK USB Port" or "MediaTek PreLoader". Once recognized, you can release the Reset button. Step 4: Flash the Unlocked Firmware
Run powerful media engines like Kodi, VLC, or MX Player to play local network files.
: Users have the freedom to customize their device settings according to their needs. This includes configuring network settings, updating firmware, and optimizing performance. Navigate to the file manager, select the APK, and install it
If your device only shows up as a generic USB device rather than a MediaTek Preloader device:
Connect the box to your local network via Wi-Fi or Ethernet. Find its IP address in the network settings (e.g., 192.168.1.105 ).
Clean up the device's storage and RAM by deleting resource-heavy provider apps.
Change your USB port (use USB 2.0 instead of USB 3.0) and verify that the MediaTek Preloader drivers are updated in your Windows Device Manager.
Select connection type, enter your COM port, and set the Speed (Baud Rate) to 115200 .