Autocraft Battery Charger Ac-60cr Manual |top| Guide

) terminal or a bare metal ground point on the vehicle chassis. : Toggle the switch to your desired mode.

Wear acid-resistant clothing and gloves. Avoid touching your eyes while working.

: May take 6–12 hours on the 6-amp setting to reach a full charge.

A massive burst of current intended solely for cranking an engine with a dead battery. Note: This mode must only be used in short bursts (typically 3 to 5 seconds) to avoid overheating the transformer. 3. Rotary Timer Switch

Autocraft 6/2 Amp Dual Rate Battery Charger 6 / 12 Volt ... - eBay autocraft battery charger ac-60cr manual

Select the correct voltage () matching your battery type.

: Compatible with both 6V and 12V systems, selectable via a front-panel switch.

Connect the clamp to the positive (+) battery post.

Connect the charger to a live, grounded 120V AC outlet. ) terminal or a bare metal ground point

Connect the clamp to the positive (+) battery terminal.

: For small batteries (motorcycles, lawn tractors) or slow-charging large batteries to improve longevity. 10 Amp (Fast Charge) : For standard automotive battery charging. Boost/Start : For emergency jump-starts. Key Hardware Features Analog Ammeter Gauge

This guide is for informational purposes and is based on a synthesis of available manuals for Autocraft products and standard industry safety practices. Always refer to your specific product's labeling and any provided documentation.

Post on forums like , Reddit r/MechanicAdvice , or DIYCarForums — someone may have a scanned copy. Avoid touching your eyes while working

Follow the "Inside the Vehicle" connection sequence outlined above.

Autocraft AC-60CR is a manual battery charger designed for standard lead-acid batteries. Because it is a manual charger, it does not automatically shut off; you must monitor the charge to prevent overcharging. Safety & Setup

What are you currently seeing on the unit?

If your vehicle's battery is completely dead and you need an immediate boost to crank the engine, use the Engine Start mode.

Ensure proper ventilation. The charger may shut down temporarily if it overheats. 7. Maintenance and Storage