Model Poh2501 Manual - Patton Heater

: For a physical or PDF copy, users often find them on secondary marketplaces like eBay.

Controls the temperature. Turn it clockwise to increase the heat. Once the room reaches your desired temperature, slowly turn it back (counter-clockwise) until you hear a "click"—the heater will now cycle on and off to maintain that level. Power/Heat Switches: Usually, there are two switches: Switch I (Low): Typically ~600W. Switch II (Medium): Typically ~900W. Both I & II (High): Combined ~1500W for maximum heat. 3. Safety Features

: Always place the heater on a firm, flat, and level surface. Never place it on beds or deep carpets where openings may get blocked.

Electric utility heaters draw a significant amount of power and generate high localized heat. Always follow these foundational safety rules to prevent fire, electrical shock, or injury. Placement and Clearance patton heater model poh2501 manual

Do you notice any blinking or unusual sounds?

Check your home breaker panel; reset the breaker or replace the fuse. Thermostat is set too low. Turn the thermostat dial clockwise to a higher setting. Tip-over switch is engaged. Ensure the heater is resting flat on a hard, level surface.

This heater is not intended for use in bathrooms, laundry areas, or damp outdoor spaces. Never place the heater where it might fall into a bathtub or water container. Operating Instructions : For a physical or PDF copy, users

Ensure the unit is on a flat surface. Most Patton models have a tip-over switch that cuts power if the unit is tilted.

The Power Selector Dial controls the fan and heating elements:

If this occurs, immediately turn the heater to OFF , unplug it, and follow the reset instructions in the troubleshooting section below. 2. Tip-Over Safety Switch Once the room reaches your desired temperature, slowly

Operating the Patton POH2501 is straightforward, utilizing manual analog knobs for temperature and mode control. Setting Up the Heater Ensure the control knob is turned to the position.

Auto-shutoff safety feature has triggered due to overheating.

Only operate the heater on flat, level, and dry surfaces. Do not place it on rugs, carpeting, or elevated surfaces like tables where it could tip over. Operating Instructions Initial Setup Carefully remove the heater from its packaging.

Turn off immediately, unplug, and vacuum the grills. If smell persists, discontinue use.