Sup0108 A Deployment Or Update Operation Is Already In Progress Best //free\\ Jun 2026

By following the systematic troubleshooting steps and best practices outlined in this guide, you can minimize downtime, reduce operational friction, and maintain a healthy firmware update process across your Dell PowerEdge infrastructure.

A previous firmware update failed or timed out during package transfer, leaving a phantom task active in the iDRAC database.

The Lifecycle Controller was not exited properly (e.g., the server was hard power-cycled during a previous maintenance window instead of using the "Exit" command).

Q: How can I prevent the SUP0108 error? A: Plan and coordinate deployments, test and monitor updates, ensure sufficient resources, and configure deployment settings carefully. By following the systematic troubleshooting steps and best

If you want, tell me what deployment system you use (e.g., Jenkins, GitHub Actions, Kubernetes, SOT, Intune, SCCM) and I’ll provide tailored commands and exact DB/lock locations.

The following solutions are listed in order of ease and effectiveness. 1. Clear the iDRAC Job Queue (Most Effective)

The most common cause is a stuck job in the queue. Clearing this allows the Lifecycle Controller to accept new instructions. Log in to the iDRAC web console. Navigate to Maintenance > Job Queue . Click Select All (or check the box for all jobs). Click Delete or Delete All . Wait a few minutes and try your deployment/update again. Q: How can I prevent the SUP0108 error

: The firmware installer creates a temporary RAM drive on the host system; if not properly unmounted after a failed run, it blocks subsequent attempts for up to 18 hours unless a cold boot is performed. Best Practices for Deployment Sequential Updates

Navigate to the or package deployment history tab.

The iDRAC firmware installer creates a temporary RAM drive on the host OS to extract update files. If an update is interrupted, this virtual lockfile fails to clear automatically. The following solutions are listed in order of

Are you deploying via a or a command-line interface (CLI) ?

"JobID": "JID_CLEARALL"

"status": "queued", "message": "A deployment is already in progress. Your request has been queued.", "position": 2, "request_id": "def-456"

Update the specific row status to FAILED or COMPLETED , or carefully remove the stale lock record. Best Practices to Prevent Future SUP0108 Errors Automate Pipeline Concurrency Controls

When a RAM drive remains stubbornly mounted or hardware registers become unresponsive, a standard warm reboot of the server will not suffice. You must perform a cold boot to drain residual flea power from the motherboard. Safely the host operating system. Unplug all power cables from the back of the server.