Programmable digital inputs (default functions: Forward, Reverse, Fault Reset, Multi-step speed).
: 150% of rated current for 60 seconds; 180% for 10 seconds.
Input line voltage is too low, a phase loss occurred on the mains supply, or the internal pre-charge contactor is faulty.
This report is a summary of typical content found in INVT CHE100 manuals. For actual installation and troubleshooting, always refer to the specific printed or PDF version of the manual provided with your specific unit hardware version. Invt CHE100 Inverter User Manualpdf
: Single-phase 220V, Three-phase 220V, or Three-phase 380V. Output Frequency : 0.00 Hz to 400.00 Hz. Overload Capacity : 150% of rated current for 60 seconds. Starting Torque : 150% at 0.5Hz (SVC). ⚡ Safety Precautions and Installation
The INVT CHE100 features advanced firmware functions that allow it to operate without a PLC in simple automated environments. Multi-Step Speed Configuration
Highlights potential risks leading to mild physical injuries, internal circuit degradation, or data corruption. Mechanical and Environmental Requirements This report is a summary of typical content
[Keypad / Modbus Input] │ ▼ ┌───────────────────────┐ │ Group F0: Core Setup │ ──► F0.00: Control Mode (Sensorless Vector) └───────────────────────┘ ──► F0.03: Max Output Frequency (0-400 Hz) │ ▼ ┌───────────────────────┐ │ Group F1: Motor Data │ ──► F1.01: Rated Motor Power (kW) └───────────────────────┘ ──► F1.02: Rated Motor Voltage (V) Essential Parameter Groups
OUT1 / OUT2 / OUT3 — Inverter Module Protection (Overcurrent)
: Configures upper limits (typically 50.00Hz or 60.00Hz). P0.06 (Source of Frequency Command) : 0 : Digital setting (Keypad potentiometer or 1 : Analog Input AI1 (External potentiometer) 2 : Analog Input AI2 Output Frequency : 0
AI1 supports standard 0–10V signals. AI2 can be toggled via internal jumpers between a 0–10V voltage signal or a 4–20mA current signal.
: Defines the upper limit of the inverter’s output (e.g., 50Hz or 60Hz).
Input power terminals (3-phase 380V). For single-phase 220V units, use L and N .
No. The CHE100 is a distinct series. While some parameters overlap with the GD100 (a more basic model), the CHE100 has additional functions like PID, Modbus, and vector control. Always use the dedicated CHE100 manual.