Use a soft, damp cloth to wipe the exterior. Never spray water directly onto the control panel. 5. Troubleshooting Common Issues
: Place the unit in an area with at least 12 inches of space around all sides to ensure unobstructed airflow.
Use this table for quick fixes:
| Display/Light | Meaning | Solution | |---------------|---------|----------| | | Coil temperature sensor failure | Unplug for 1 hour, then restart. If persists, contact support. | | E2 | Humidity sensor failure | Same as above – possible circuit board issue. | | CL / LC | Low temperature protection (below 41°F) | Move unit to warmer room or use a different appliance. | | FULL | Water tank full or misaligned | Empty tank and reseat securely. Check float. | | Frost on coils | Unit is defrosting (normal) | Do not turn off. Wait 10-30 minutes; unit will resume dehumidifying. | | Unit runs but no water in tank | Room humidity is below set point (e.g., dry room) | Lower target humidity or run in Continuous mode. |
Normal operation. The unit removes water by condensing it, releasing heat as a byproduct. Room temp may rise 2–4°F.
Open the box carefully and verify you have:
Switch between "Auto" (maintains a set level) and "Continuous" (runs regardless of humidity level—ideal for drying clothes).